SH7052 datasheet(347/919 Pages) RENESAS

347 / 919 page

321

Correction Counter 10E (TCNT10E): Correction counter 10E (TCNT10E) is a 16-bit

readable/writable register that loads the TCNT10D shift value at the external input (TI10) timing,

and counts on the multiplied clock (AGCK1) output by reload counter 10C (TCNT10C).

However, if CCS in timer I/O control register 10 (TIOR10) is set to 1, when the TCNT10D shifted

value is reached the count is halted.

Bit:

Initial value:

R/W: R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W

TCNT10E can only be accessed by a word read or write.

TCNT10E is initialized to H'0000 by a power-on reset, and in hardware standby mode and

software standby mode.

Correction Counter 10F (TCNT10F): Correction counter 10F (TCNT10F) is a 16-bit

readable/writable register that counts up if the counter value is smaller than the correction counter

10E (TCNT10E) value when the STR10 bit in TSTR1 has been set for counter operation. The

count is halted by a match with the correction counter clear register (TCCLR10). If TI10 is input

when TCNT10D = H'0000, TCNT10F is initialized and correction is carried out. When TCNT10F

= TCCLR10, TCNT10F is cleared to H'0001. While TCNT10F

≠ TCCLR10, TCNT10F is

incremented automatically until it reaches the TCCLR10 value, and is then cleared to H'0001.

A corrected clock (AGCKM) is output following correction each time this counter is incremented.

Bit:

Initial value:

R/W: R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W

TCNT10F is can only be accessed by a word read or write.

TCNT10F is initialized to H'0001 by a power-on reset, and in hardware standby mode and

software standby mode.

SH7052 데이터시트(PDF) 347 Page - Renesas Technology Corp