SH7052 datasheet(139/919 Pages) RENESAS

139 / 919 page

113

7.5.3

Contention between User Break and Exception Processing

If a user break is set for the fetch of a particular instruction, and exception processing with higher

priority than a user break is in contention and is accepted in the decode stage for that instruction

(or the next instruction), user break exception processing may not be performed after completion

of the higher-priority exception service routine (on return by RTE).

Thus, if a user break condition is applied to the branch destination instruction fetch after a branch

(BRA, BRAF, BT, BF, BT/S, BF/S, BSR, BSRF, JMP, JSR, RTS, RTE, exception processing),

and that branch instruction accepts exception processing with higher priority than a user break

interrupt, user break exception processing is not performed after completion of the higher-priority

exception service routine.

Therefore, a user break condition should not be set for the fetch of the branch destination

instruction after a branch.

7.5.4

Break at Non-Delay Branch Instruction Jump Destination

When a branch instruction with no delay slot (including exception processing) jumps to the jump

destination instruction on execution of the branch, a user break will not be generated even if a user

break condition has been set for the first jump destination instruction fetch.

7.5.5

User Break Trigger Output

Information on internal bus condition matches monitored by the UBC is output as

UBCTRG. The

trigger width can be set with clock select bits 1 and 0 (CKS1, CKS0) in the user break control

If a condition matches occurs again during trigger output, the

UBCTRG pin continues to output a

low level, and outputs a pulse of the length set in bits CKS1 and CKS0 from the cycle in which the

last condition match occurs.

The trigger output conditions differ from those in the case of a user break interrupt when a CPU

instruction fetch condition is satisfied. When a condition occurs in an overrun fetch instruction as

described in section 7.5.2, Instruction Fetch at Branches, a user break interrupt is not requested but

a trigger is output from the

UBCTRG pin.

In other CPU data accesses and DMAC bus cycles, pulse output is performed under conditions

similar to user break interrupt conditions.

Setting the user break interrupt disable (UBID) bit to 1 in UBCR enables trigger output to be

monitored externally without requesting a user break interrupt.

SH7052 데이터시트(PDF) 139 Page - Renesas Technology Corp