ATmega162 datasheet(238/324 Pages) ATMEL

238 / 324 page

238

2513K–AVR–07/09

ATmega162/V

While the lower bits in the address are mapped to words within the page, the higher bits address

the pages within the FLASH. This is illustrated in Figure 97 on page 238. Note that if less than

eight bits are required to address words in the page (pagesize < 256), the most significant bit(s)

in the address low byte are used to address the page when performing a Page Write.

G. Load Address High byte

Set XA1, XA0 to “00”. This enables address loading.

Set BS1 to “1”. This selects high address.

Set DATA = Address high byte (0x00 - 0xFF).

Give XTAL1 a positive pulse. This loads the address high byte.

H. Program Page

Give WR a negative pulse. This starts programming of the entire page of data. RDY/BSY

goes low.

Wait until RDY/BSY goes high. (See Figure 98 for signal waveforms)

I. Repeat B through H until the entire Flash is programmed or until all data has been

programmed.

J. End Page Programming

1. Set XA1, XA0 to “10”. This enables command loading.

Set DATA to “0000 0000”. This is the command for No Operation.

Give XTAL1 a positive pulse. This loads the command, and the internal write signals are

reset.

Figure 97. Addressing the Flash which is Organized in Pages

(1)

Note:

1. PCPAGE and PCWORD are listed in Table 105 on page 236.

PROGRAM MEMORY

WORD ADDRESS

WITHIN A PAGE

PAGE ADDRESS

WITHIN THE FLASH

INSTRUCTION WORD

PAGE

PCWORD[PAGEMSB:0]:

PAGEEND

PAGE

PCWORD

PCPAGE

PCMSB

PAGEMSB

PROGRAM

COUNTER

ATmega162 데이터시트(PDF) 238 Page - ATMEL Corporation

ATmega162 데이터시트(HTML) 238 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL