360J datasheet(13/68 Pages) INTEL

13 / 68 page

Datasheet

Low Power Features

is in the Sleep State, the SLP# and STPCLK# signals should be deasserted immediately

after RESET# is asserted to ensure the processor correctly executes the reset

sequence.

While in the Sleep state, the processor is capable of entering an even lower power

state, the Deep Sleep state by asserting the DPSLP# pin. (See Section 2.1.6.) While

the processor is in the Sleep state, the SLP# pin must be deasserted if another

asynchronous FSB event needs to occur.

2.1.6

Deep Sleep State

Deep Sleep state is a very low power state the processor can enter while maintaining

context. Deep Sleep state is entered by asserting the DPSLP# pin while in the Sleep

state. BCLK may be stopped during the Deep Sleep state for additional platform level

power savings. BCLK stop/restart timings on 855PM chipset family based platforms

with compatible clock generator chips are as follows:

• Deep Sleep entry - DPSLP# and CPU_STP# are asserted simultaneously. The clock

chip will stop/tristate BCLK within two BCLKs +/- a few nanoseconds.

• Deep Sleep exit - DPSLP# and CPU_STP# are deasserted simultaneously. The clock

chip will drive BCLK to differential DC levels within 2-3 ns and starts toggling BCLK

2-6 BCLK periods later.

To re-enter the Sleep state, the DPSLP# pin must be deasserted. BCLK can be restarted

after DPSLP# deassertion as described above. A period of 30 microseconds (to allow for

PLL stabilization) must occur before the processor can be considered to be in the Sleep

State. Once in the Sleep state, the SLP# pin must be deasserted to re-enter the Stop-

Grant state.

While in Deep Sleep state, the processor is incapable of responding to snoop

transactions or latching interrupt signals. No transitions of signals are allowed on the

FSB while the processor is in Deep Sleep state. Any transition on an input signal before

the processor has returned to Stop-Grant state will result in unpredictable behavior.

When the processor is in Deep Sleep state, it will not respond to interrupts or snoop

transactions.

2.2

FSB Low Power Enhancements

The Celeron M processor incorporates the FSB low power enhancements:

• Dynamic FSB Power Down

• BPRI# control for address and control input buffers

• Dynamic On Die Termination disabling

• Low VCCP (I/O termination voltage)

The Celeron M processor incorporates the DPWR# signal that controls the data bus

input buffers on the processor. The DPWR# signal disables the buffers when not used

and activates them only when data bus activity occurs, resulting in significant power

savings with no performance impact. BPRI# control also allows the processor address

and control input buffers to be turned off when the BPRI# signal is inactive. The on-die

termination on the processor FSB buffers is disabled when the signals are driven low,

resulting in additional power savings. The low I/O termination voltage is on a dedicated

voltage plane independent of the core voltage, enabling low I/O switching power at all

times.

360J 데이터시트(PDF) 13 Page - Intel Corporation

360J 데이터시트(HTML) 13 Page - Intel Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68

데이터시트 다운로드

링크 URL