WM9093ECSSLASHR datasheet(77/84 Pages) WOLFSON

77 / 84 page

Production Data

WM9093

PD, March 2012, Rev 4.2

APPLICATIONS INFORMATION

RECOMMENDED EXTERNAL COMPONENTS

AUDIO INPUT PATHS

The WM9093 provides 6 analogue audio inputs. Each of these inputs is referenced to the internal DC

reference, VMID. A DC blocking capacitor is required for each input pin used in the target application.

The choice of capacitor is determined by the filter that is formed between that capacitor and the input

impedance of the input pin. The circuit is illustrated in Figure 16.

Figure 16 Audio Input Path DC Blocking Capacitor

If the input impedance is known, and the cut-off frequency is known, then the minimum capacitor

value may be derived easily. However, it can be seen from the representation in Figure 16 that the

input impedance is not fixed in all applications but can vary with gain and boost amplifier settings. The

choice of capacitor for a 20Hz cut-off frequency is shown in Table 35 for different input impedance

conditions. The applicable input impedance can be found in the “Electrical Characteristics” section of

this datasheet.

INPUT IMPEDANCE

MINIMUM CAPACITANCE

FOR 20HZ PASS BAND



F

15k



0.5

F

30k



0.27

F

60k



0.13

F

Table 35 Audio Input DC Blocking Capacitors

Using the figures in Table 35, it follows that a 1

F capacitance for all input connections will give good

results in most cases. Tantalum electrolytic capacitors are particularly suitable as they offer high

stability in a small package size.

Ceramic equivalents are a cost effective alternative to the superior tantalum packages, but care must

be taken to ensure the desired capacitance is maintained at the HPVDD operating voltage. Also,

ceramic capacitors may show microphonic effects, where vibrations and mechanical conditions give

rise to electrical signals. This is particularly problematic for microphone input paths where a large

signal gain is required.

A single capacitor is required for a line input or single-ended microphone connection. In the case of a

differential connection, a DC blocking capacitor is required on both input pins.

WM9093ECS/R 데이터시트(PDF) 77 Page - Wolfson Microelectronics plc

WM9093ECS/R 데이터시트(HTML) 77 Page - Wolfson Microelectronics plc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84

데이터시트 다운로드

링크 URL