WM9093ECSSLASHR datasheet(15/84 Pages) WOLFSON

15 / 84 page

Production Data

WM9093

PD, March 2012, Rev 4.2

DEVICE DESCRIPTION

INTRODUCTION

The WM9093 is an ultra-low power, high quality audio subsystem, including a headphone and

speaker driver. Its flexible architecture is designed to interface with a wide range of analogue

components. The small 2.0 x 2.5mm footprint makes it ideal for portable applications such as mobile

handsets.

Four flexible analogue input pins allow interfacing to up to four single-ended or two differential input

sources. Connection to an external voice CODEC, FM radio, melody IC or generic line input are all

fully supported. Signal routing to the output mixers provides maximum flexibility to support a wide

variety of usage modes. An additional differential ‘Voice Bypass’ path direct to the Earpiece output

driver is also included.

Three analogue output drivers are integrated, including a high quality Class D/AB switchable speaker

driver supporting 650mW output power at 3.6V in Class D mode. In Class AB mode, the driver is

suitable for driving an earpiece via the low-power differential ‘Voice Bypass’ path. A configurable

automatic gain control (AGC) is provided on the speaker output path, to prevent clipping or power

overload at the loudspeaker.

Ground-referenced stereo headphone outputs are also provided; these are powered from an

integrated Charge Pump, enabling high quality, power efficient headphone playback. The ground-

referenced design reduces power consumption, improves bass response, and enables direct

headphone connection without any DC blocking capacitors. A DC Servo circuit is provided for DC

offset measurement and correction, thereby suppressing pops and reducing power consumption.

Internal differential signal routing and amplifier configurations have been optimised to provide the

lowest possible power consumption for a wide range of usage scenarios, including voice calls and

music playback. The speaker drivers offer low leakage and high PSRR; this enables direct connection

to a Lithium battery. The speaker driver provides eight levels of boost gain to allow output signal

levels to be maximised for many commonly-used SVDD/HPVDD combinations.

An integrated oscillator is provided to support all the WM9093 clocking requirements, including the

Class D switching clock, Headphone Charge Pump and DC Servo control.

The WM9093 is controlled via a standard 2-wire I2C interface, providing full software control of all

features, together with device register readback. The interface provides support for I/O voltages up to

2.7V. An integrated Control Write Sequencer enables automatic scheduling of control sequences;

commonly-used signal configurations may be selected using ready-programmed sequences,

including time-optimised control of the WM9093 pop suppression features. Unused circuitry can be

disabled under software control, in order to save power; low leakage currents enable extended

standby/off time in portable battery-powered applications.

WM9093ECS/R 데이터시트(PDF) 15 Page - Wolfson Microelectronics plc