376 datasheet(55/95 Pages) INTEL

55 / 95 page

376 EMBEDDED PROCESSOR

240182 – 32

NOTE

HOLD is a synchronous input and can be asserted at any CLK2 edge provided setup and hold (t23 and t24) require-

ments are met This waveform is useful for determining Hold Acknowledge latency

Figure 417 Requesting Hold from Active Bus (NA Inactive)

guaranteed to enter FLOAT in a valid state After

deactivating FLT the 80376 is not guaranteed to

exit FLOAT mode in a valid state This is not a prob-

lem as the FLT pin is meant to be used only during

ONCE After exiting FLOAT the 80376 must be re-

set to return it to a valid state Reset should be as-

serted before FLT is deasserted This will ensure

that the 80376 will exit float in a valid state

FLT has an internal pull-up resistor and if it is not

used it should be unconnected

BUS ACTIVITY DURING AND FOLLOWING

RESET

RESET is the highest priority input signal capable of

interrupting any processor activity when it is assert-

ed A bus cycle in progress can be aborted at any

stage or idle states or bus hold acknowledge states

discontinued so that the reset state is established

RESET should remain asserted for at least 15 CLK2

periods to ensure it is recognized throughout the

80376 and at least 80 CLK2 periods if a 80376 self-

test is going to be requested at the falling edge RE-

SET asserted pulses less than 15 CLK2 periods may

not be recognized RESET pulses less than 80 CLK2

periods followed by a self-test may cause the self-

test to report a failure when no true failure exists

Provided the RESET falling edge meets setup and

hold times t25 and t26 the internal processor clock

phase is defined at that time as illustrated by Figure

419 and Figure 67

376 데이터시트(PDF) 55 Page - Intel Corporation