RM0312 datasheet(215/275 Pages) STMICROELECTRONICS

215 / 275 page

DocID022352 Rev 3

215/275

RM0312

Serial peripheral interface (SPI)

223

It is reset:

•

when a transfer is finished (except in master mode if the communication is continuous)

•

when the SPI is disabled

•

when a master mode fault occurs (MODF = 1)

When communication is not continuous, the BSY flag is low between each communication.

When communication is continuous, in master mode, the BSY flag is kept high during the

whole transfers.

When communication is continuous, in slave mode, the BSY flag goes back to low state for

one SPI clock cycle between each transfer.

Note:

Do not use the BSY flag to handle each data transmission or reception. It is better to use

TXE and RXNE flags instead.

20.3.7

Disabling the SPI

When a transfer is terminated, the application can stop the communication by disabling the

SPI peripheral. This is done by resetting the SPE bit.

For some configurations, disabling the SPI and entering Halt mode while a transfer is on-

going, can cause the current transfer to be corrupted and/or it can happen that the BSY flag

becomes unreliable.

To avoid any of these effects, it is recommended to respect the following procedure when

disabling the SPI:

In master or slave full duplex mode (BDM = 0, RXONLY = 0):

Wait until RXNE = 1 to receive the last data

Wait until TXE = 1

Then wait until BSY = 0

Disable the SPI (SPE = 0) and eventually enter Halt mode (or disable the peripheral

clock).

In master or slave unidirectional transmit-only mode (BDM = 0, RXONLY = 0)

or bidirectional transmit mode (BDM = 1, BDOE = 1):

After the last data is written in the SPI_DR register:

Wait until TXE = 1

Then wait until BSY = 0

Disable the SPI (SPE = 0) and, if desired, enter Halt mode (or disable the peripheral

clock).

RM0312 데이터시트(PDF) 215 Page - STMicroelectronics

RM0312 데이터시트(HTML) 215 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL