ST25TA02K-P datasheet(49/64 Pages) STMICROELECTRONICS

49 / 64 page

DocID027794 Rev 2

49/64

ST25TA02K-P

RF command sets

The FSCI codes the FSC which stands for the maximum frame size that the ST25TA02K-P

is able to receive. The ST25TA02K-P is able to receive up to 64 bytes of command. If the

RF host sends a command with more than 64 bytes, the ST25TA02K-P will not be able to

treat the command and will not reply.

The FWI which stands for the Frame Waiting time Integer codes the FWT. This time

corresponds to the maximum duration while an RF host shall send before sending the next

command.

The SFGI which stands for the Start-up Frame Guard Time is the minimum time that the

reader shall wait after receiving the response of the ST25TA02K-P.

5.9.3

PPS command & response(b)

PPS (Protocol and Parameter Selection) command and response are defined in ISO/IEC

14443-4, in the Protocol Activation of PICC Type A.

The PPS command allows to change the data rates of the ascending (RF host to

ST25TA02K-P) and descending (ST25TA02K-P to RF host) data rates. Usage of this

command is optional, ST25TA02K-P only supports 106 Kb/s in both direction.

Table 51. ATS response

Name

TA(1)

TB(1)

TC(1)

CRC

Byte field

0x05

0x75

0x80

0x60

0x02

2 bytes

Bit field

b8-b5

b4-b1

Length of the ATS

response

FSCI = 5 => FSC = 64 bytes

The maximum ascending data rate is 106 kbps

The maximum descending data rate is 106 kbps

FWI field (FWI = 6 => FWT = 19.2 ms)

SFGI field (SFGI = 0 => SFGT =302 µs)

The DID is supported

2 CRC bytes

b. Not useful in case of ST25TA02K-P which only support a Data Rate of 106 Kb/s in both direction.

ST25TA02K-P 데이터시트(PDF) 49 Page - STMicroelectronics

ST25TA02K-P 데이터시트(HTML) 49 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64

데이터시트 다운로드

링크 URL