TMS320DM641 datasheet(31/171 Pages) TI

31 / 171 page

Bootmode

June 2003 − Revised August 2004

SPRS222C

1.8

Bootmode

The DM641/DM640 device resets using the active-low signal RESET. While RESET is low, the device is held

in reset and is initialized to the prescribed reset state. Refer to reset timing for reset timing characteristics and

states of device pins during reset. The release of RESET starts the processor running with the prescribed

device configuration and boot mode.

The DM641 has three types of boot modes while the DM640 has only two types of boot modes:

•

Host boot [DM641 only]

If host boot is selected, upon release of RESET, the CPU is internally “stalled” while the remainder of the

device is released. During this period, an external host can initialize the CPU’s memory space as

necessary through the host interface, including internal configuration registers, such as those that control

the EMIF or other peripherals. For the DM641 device, the HPI peripheral is used for host boot. Once the

host is finished with all necessary initialization, it must set the DSPINT bit in the HPIC register to complete

the boot process. This transition causes the boot configuration logic to bring the CPU out of the “stalled”

state. The CPU then begins execution from address 0. The DSPINT condition is not latched by the CPU,

because it occurs while the CPU is still internally “stalled”. Also, DSPINT brings the CPU out of the “stalled”

state only if the host boot process is selected. All memory may be written to and read by the host. This

allows for the host to verify what it sends to the DSP if required. After the CPU is out of the “stalled” state,

the CPU needs to clear the DSPINT, otherwise, no more DSPINTs can be received.

•

EMIF boot (using default ROM timings)

Upon the release of RESET, the 1K-Byte ROM code located in the beginning of CE1 is copied to address 0

by the EDMA using the default ROM timings, while the CPU is internally “stalled”. The data should be

stored in the endian format that the system is using. In this case, the EMIF automatically assembles

consecutive 8-bit bytes to form the 32-bit instruction words to be copied. The transfer is automatically done

by the EDMA as a single-frame block transfer from the ROM to address 0. After completion of the block

transfer, the CPU is released from the “stalled” state and starts running from address 0.

•

No boot

With no boot, the CPU begins direct execution from the memory located at address 0. Note: operation is

undefined if invalid code is located at address 0.

TMS320DM641 데이터시트(PDF) 31 Page - Texas Instruments