PM5347 datasheet(101/302 Pages) PMC

101 / 302 page

PM5347 S/UNI-PLUS

DATA SHEET

PMC-941033

ISSUE 6

SATURN USER NETWORK INTERFACE PLUS

PROPRIETARY AND CONFIDENTIAL TO PMC-SIERRA, INC., AND FOR ITS CUSTOMERS’ INTERNAL USE

of the loopback point continue to operate normally. For example line AIS may

be inserted in the transmit stream upstream of the loopback point using the

TSOP Control register.

SDLE:

The SDLE bit enables the serial diagnostic loopback. When SDLE is a logic

one, the transmit serial stream is connected to the receive stream. The SDLE

and the LLE bits should not be set high simultaneously.

LLE:

The LLE bit enables the S/UNI-PLUS line loopback. When LLE is a logic one,

RXD+ and RXD- are connected internally to TXD+ and TXD- respectively.

The SDLE and the LLE bits should not be set high simultaneously.

RXDINV:

The RXDINV bits select the polarity of the RXD+/- signals. The default

configuration selects RXD+ (RXD-) to be high (low) when the receive stream

contains a logic one. When RXDINV is a logic one, RXD+/- is inverted;

RXD+(RXD-) is low (high) when the receive stream contains a logic one.

RCAINV:

The RCAINV bits select the active polarity of the RCA signal. The default

configuration selects RCA to be active high, indicating that a received cell is

available when high. When RCAINV is a logic one, the RCA signal becomes

active low.

TCAINV:

The TCAINV bits select the active polarity of the TCA signal. The default

configuration selects TCA to be active high, indicating that a cell is available

in the transmit FIFO when high. When TCAINV is a logic one, the TCA signal

becomes active low.

PM5347 데이터시트(PDF) 101 Page - PMC-Sierra, Inc