STGAP1S datasheet(35/67 Pages) STMICROELECTRONICS

35 / 67 page

DocID027190 Rev 3

35/67

STGAP1S

Functional description

This configuration overrides some drawbacks of using the 2LTO at each turn-off, such as

the minimum pulse width equal to t2LTOtime and the turn-on delay needed to avoid duty cycle

distortion.

With this configuration the turn-off is only slowed down in case of desaturation or

overcurrent events.

Figure 16. Example of operation with 2LTO in “Fault” mode

7.10.3

Never

The 2LTO function is disabled (2LTOtime = 0x0). In this case a standard turn-off sequence is

used (directly lowering the gate voltage from VH to VL) also in case of desaturation or sense

overcurrent events.

7.11

Failure management

The device provides advanced diagnostic through open drain outputs (DIAG1/DIAG2) and

internal status registers. The DIAG2 output shares the same pin of the IN- input (see

Figure 1 on page 8); the diagnostic signal through the pin is enabled through the DIAG_EN

pin as described in Section 7.1 on page 25.

Status registers (STATUS1, STATUS2 and STATUS3) provide failures and status

information as listed in respective paragraphs.

DIAG1 and DIAG2 pins can be programmed through the dedicated registers (DIAG1 and

DIAG2) to signal one or more failure conditions. The output value is the result of the NOR of

the selected status bits: if one of the selected bits is high, the output is forced low.

Some of the failure conditions reported by the status registers are latched, i.e.: the flag is

kept high even if the triggering condition is expired. In this case the failure flag can be

released in following ways:



Using the ResetStatus command (all flags are released)



Forcing low the SD pin for at least trelease when the SD_FLAG configuration bit is set

high. All the flags are released at the SD rising edge.



Using HW reset (see Section 7.3 on page 29). In this case the device behaves as after

power-up sequence.

In any case, if the failure condition is still present, the respective flag is not released.

tDon

t2LTOtime

tDoff

tDESAT

INAND

GON-GOFF

VDESATth

DESAT

tDoff

tDon

STGAP1S 데이터시트(PDF) 35 Page - STMicroelectronics

STGAP1S 데이터시트(HTML) 35 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67

데이터시트 다운로드

링크 URL