MAS3587F datasheet(32/82 Pages) MICRONAS

32 / 82 page

MAS 3587F

ADVANCE INFORMATION

Micronas

3.3.2. List of DSP Registers

Table 3–5 lists the registers used in the standard firmware (MPEG) and for the download option (Download).

Note: Registers not given in the tables must not be written.

3.3.3. List of DSP Memory Cells

Among the user interface control memory cells there

are some which have a global meaning and some

which control application specific parts of the DSP

core. In the tables below this is reflected by the key-

words All, Encoder and Decoder.

3.3.3.1. Application Select and Running

The AppSelect cell is a global user interface configura-

tion cell, which has to be written in order to start a spe-

cific application.

The AppRunning cell is a global user interface status

cell, which indicates, which application loop is actually

running.

The meaning of the bits in both cells is given in Table

3–6.

Following steps have to be performed to switch

between applications:

– write “0” to AppSelect

– check AppRunning for “0”

– apply necessary/wanted Control settings

– write value to AppSelect according to Table 3–6

3.3.3.2. Application Specific Control

The configuration of the MPEG Encoder and Decoder

firmware is done via the control memory cells

described in Table 3–7. The changes applied to any of

the control memory cells have to be validated by set-

ting bit[0] of memory cell Main I/O Control except when

the application is started by writing the AppSelect

memory cell. The validate bit will be reset automati-

cally after the changes have been taken over by the

DSP.

The status memory cells are used to read the encoder/

decoder status and to get additional MPEG bitstream

information.

Note: Memory cells not given in the tables must not be

written.

Table 3–5: DSP Register Table

Address

(hex)

R/W

FunctionMode

Default

(hex)

Name

R/W

Configuration of Variable RAM Areas

Download

Affected RAM area

bit[19]

D0:800 ... D0:BFF

bit[18]

D0:C00 ... D0:FFF

bit[17]

D1:800 ... D1:BFF

bit[16]

D1:C00 ... D1:FFF

This register is used to switch four RAM areas from data

to program usage and thus enabling the DSP’s program

counter to access downloaded program code stored at

these locations. For normal operation (firmware in ROM)

this register must be kept to zero.

For details of program code download please refer to

Section 3.3.1.14.

0000

PSelect_Shadow

S/PDIF1) Input Channel Status Bits

MPEG

bit[15:0]

channel status bits of incoming signal.

0000

SPIChannelStatus

1) IEC 958 Amendment1, “Digital Audio Interface”

MAS3587F 데이터시트(PDF) 32 Page - Micronas

MAS3587F 데이터시트(HTML) 32 Page - Micronas

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82

데이터시트 다운로드

링크 URL