SPEAR600 datasheet(23/97 Pages) STMICROELECTRONICS

23 / 97 page

SPEAr600

Architecture overview

Doc ID 16259 Rev 3

23/97

–

4 dual port memory cuts (1024 words x 32 bits)

●

Clock system constituted by:

–

5 clocks coming from the external balls

–

4 clocks coming from the integrated frequency synthesizers

–

CPU core clock frequency

–

Pll2 frequency

–

48 MHz clock (USB Pll)

–

30 MHz clock (Main Oscillator)

–

32.768 kHz clock (RTC Oscillator)

–

APB clock (programmable)

–

AHB clock (programmable)

–

User Configurable sync/async clock towards Memory Controller port 2 (M2)

●

Connection with 84/112 I/Os

●

Connection with 9 LVDS lines

●

12 interrupt lines towards CPU1 and CPU2

●

64 interrupt input lines from the various platform IP sources

●

16 peripheral DMA request lines

●

64 user configurable (in the SoC) general purpose input lines

●

64 user configurable (in the RAS) general purpose output lines

●

SoC dynamic power management control interface;

●

50 specific ATE Test interface signals dedicated to RAS

2.25

External Port Controller (EXPI I/F)

The port controller is a socket communication interface between the SPEAr600 and an

external FPGA device; it implements a simple AHB bidirectional protocol used to compress

a couple of std AHB master/slave bus onto 84 PL_GPIOs and 4 PL_CLK primary signals.

Caution:

PL_GPIO pins are not configurable by software.

ST provide a symmetric port controller logic solution to be embedded inside the external

FPGA with the purpose of interfacing the EXPI bus directly and decompressing the same

pair of AHB master/slave ports on the FPGA side in order to interconnect the customer logic

as follows (more slave and master agents can be connected to the EXPI):

SPEAr600_AHB-master >> FPGA_AHB-slave

SPEAr600_AHB-slave << FPGA_AHB-master (AHB-full)

The EXPI interface is based on two main groups of signals:

●

AHB bidirectional signal bus driven alternatively from the SPEAr600 and FPGA side.

●

Unidirectional signals continuously driven from both the SPEAr600 and FPGA sides.

Table 36: EXPI - pad signal assignment lists the EXPI signal names. Further details in these

signals are given in the SPEAr600 user manual (UM0510)

SPEAR600 데이터시트(PDF) 23 Page - STMicroelectronics

SPEAR600 데이터시트(HTML) 23 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97

데이터시트 다운로드

링크 URL