HCS08 datasheet(36/374 Pages) NXP

36 / 374 page

Chapter 3 Modes of Operation

MC9S08JM60 Series Data Sheet, Rev. 5

Freescale Semiconductor

After entering active background mode, the CPU is held in a suspended state waiting for serial background

commands rather than executing instructions from the user application program.

Background commands are of two types:

•

Non-intrusive commands, defined as commands that can be issued while the user program is

running. Non-intrusive commands can be issued through the BKGD pin while the MCU is in run

mode; non-intrusive commands can also be executed when the MCU is in the active background

mode. Non-intrusive commands include:

— Memory access commands

— Memory-access-with-status commands

— BDC register access commands

— The BACKGROUND command

•

Active background commands, which can only be executed while the MCU is in active background

mode. Active background commands include commands to:

— Read or write CPU registers

— Trace one user program instruction at a time

— Leave active background mode to return to the user application program (GO)

The active background mode is used to program a bootloader or user application program into the flash

program memory before the MCU is operated in run mode for the first time. When the MC9S08JM60

series is shipped from the Freescale factory, the flash program memory is erased by default unless

specifically noted, so there is no program that could be executed in run mode until the flash memory is

initially programmed. The active background mode can also be used to erase and reprogram the flash

memory after it has been previously programmed.

For additional information about the active background mode, refer to Chapter 18, “Development

Support.”

3.5

Wait Mode

Wait mode is entered by executing a WAIT instruction. Upon execution of the WAIT instruction, the CPU

enters a low-power state in which it is not clocked. The I bit in the condition code register (CCR) is cleared

when the CPU enters wait mode, enabling interrupts. When an interrupt request occurs, the CPU exits wait

mode and resumes processing, beginning with the stacking operations leading to the interrupt service

routine.

While the MCU is in wait mode, there are some restrictions on which background debug commands can

be used.

•

Only the BACKGROUND command and memory-access-with-status commands are available

while the MCU is in wait mode.

•

The memory-access-with-status commands do not allow memory access, but they report an error

indicating that the MCU is in stop or wait mode.

•

The BACKGROUND command can be used to wake the MCU from wait mode and enter active

background mode.

HCS08 데이터시트(PDF) 36 Page - NXP Semiconductors

HCS08 데이터시트(HTML) 36 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL