HCS08 datasheet(55/374 Pages) NXP

55 / 374 page

Chapter 4 Memory

MC9S08JM60 Series Data Sheet, Rev. 5

Freescale Semiconductor

Figure 4-3. Flash Burst Program Flowchart

4.5.5

Access Errors

An access error occurs whenever the command execution protocol is violated.

Any of the following specific actions will cause the access error flag (FACCERR) in FSTAT to be set.

FACCERR must be cleared by writing a 1 to FACCERR in FSTAT before any command can be processed.

•

Writing to a flash address before the internal flash clock frequency has been set by writing to the

FCDIV register

•

Writing to a flash address while FCBEF is not set (A new command cannot be started until the

command buffer is empty.)

•

Writing a second time to a flash address before launching the previous command (There is only

one write to flash for every command.)

FCBEF ?

START

WRITE TO FLASH

TO BUFFER ADDRESS AND DATA

WRITE COMMAND (0x25) TO FCMD

YES

FPVIO OR

WRITE 1 TO FCBEF

TO LAUNCH COMMAND

AND CLEAR FCBEF (Note 2)

YES

NEW BURST COMMAND ?

FCCF ?

ERROR EXIT

DONE

Note 2:

Wait at least four bus cycles before

FACCERR ?

CLEAR ERROR

FACCERR ?

Note 1:

Required only once after reset.

WRITE TO FCDIV (Note 1)

checking FCBEF or FCCF.

FLASH BURST

PROGRAM FLOW

HCS08 데이터시트(PDF) 55 Page - NXP Semiconductors

HCS08 데이터시트(HTML) 55 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL