| 전자부품 데이터시트 검색엔진 |
|
AM79C978AVCW 데이터시트(PDF) 137 Page - Advanced Micro Devices |
|
|
|||||||||||||||||||||||||||||
AM79C978AVCW 데이터시트(HTML) 137 Page - Advanced Micro Devices |
|
137 / 256 page ![]() Am79C978A 137 Transmit FIFO without FIFO overflow. Transmit DMA is re- quested at any time when the number of bytes specified by XMTFW could be written to the FIFO without causing Transmit FIFO overflow and the internal microcode engine has reached a point where the Transmit FIFO is checked to determine if DMA servicing is required. When operating in the NO- SRAM mode (no SRAM en- abled) and SRAM_SIZE is set to 0, the Bus Transmit FIFO and the MAC Transmit FIFO operate like a single FIFO and the water- mark value selected by XMT- FW[1:0] sets the number of FIFO byte locations that must be avail- able in the FIFO before receive DMA is requested. When operating with the SRAM, the Bus Transmit FIFO and the MAC Transmit FIFO operate in- dependently on the bus side and MAC side of the SRAM, respec- tively. In this case, the watermark value set by XMTFW[1:0] sets the number of FIFO byte locations that must be available in the Bus Transmit FIFO. See Table 35. These bits are read/write acces- sible only when either the STOP or the SPND bit is set. XMTFW is set to a value of 00b (16 bytes) af- ter H_RESET or S_RESET and is unaffected by STOP. 7-0 DMATC[7:0] DMA Transfer Counter. Writing and reading to this field has no ef- fect. Use MAX_LAT and MIN_GNT in the PCI configuration space. CSR82: Transmit Descriptor Address Pointer Lower Bit Name Description 31-16 RES Reserved locations. Written as zeros and read as undefined. 15-0 TXDAPL Contains the lower 16 bits of the transmit descriptor address cor- responding to the last buffer of the previous transmit frame. If the previous transmit frame did not use buffer chaining, then TXDAPL contains the lower 16 bits of the previous frame’s transmit descriptor address. When both the STOP or SPND bits are cleared, this register is up- dated by the Am79C978A control- ler immediately before a transmit descriptor write. Read accessible always. Write ac- cessible through the PXDAL bits (CSR60) when the STOP or SPND bit is set. TXDAPL is set to 0 by H_RESET and are unaffected by S_RESET or STOP. CSR84: DMA Address Register Lower Bit Name Description 31-16 RES Reserved locations. Written as zeros and read as undefined. 15-0 DMABAL This register contains the low- er 16 bits of the address of system memory for the current DMA cycle. The Bus Interface Unit controls the Address Reg- ister by issuing increment commands to increment the memory address for sequential operations. The DMABAL reg- ister is undefined until the first Am79C978A controller DMA operation. These bits are read/write acces- sible only when either the STOP or the SPND bit is set. These bits are unaffected by H_RESET, S_RESET, or STOP. Table 35. Transmit Watermark Programming XMTFW[1:0] Bytes Available 00 16 01 64 10 108 11 Reserved |
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |