SH7041A datasheet(452/923 Pages) RENESAS

452 / 923 page

414

(1) Operation when Error Occurs during Normal Mode Operation, and Operation is

Restarted in Normal Mode: Figure 12.96 shows an explanatory diagram of the case where an

error occurs in normal mode and operation is restarted in normal mode after re-setting.

RESET

TMDR

(normal)

TOER

(1)

PFC

(MTU)

TIOR

(1 init

0 out)

TSTR

(1)

Match

Error

occurs

PFC

(PORT)

TSTR

(0)

TMDR

(normal)

TIOR

(1 init

0 out)

PFC

(MTU)

TSTR

(1)

MTU output

TIOC*A

TIOC*B

Port output

PEn

n=0 to 15

High-Z

Figure 12.96 Error Occurrence in Normal Mode, Recovery in Normal Mode

1.After a reset, MTU output is low and ports are in the high-impedance state.

2.After a reset, the TMDR setting is for normal mode.

3.For channels 3 and 4, enable output with TOER before initializing the pins with TIOR.

4.Initialize the pins with TIOR.

(The example shows initial high output, with low output on

compare-match occurrence.)

5.Set MTU output with the PFC.

6.The count operation is started by TSTR.

7.Output goes low on compare-match occurrence.

8.An error occurs.

9.Set port output with the PFC and output the inverse of the active level.

10. The count operation is stopped by TSTR.

11. Not necessary when restarting in normal mode.

12.Initialize the pins with TIOR.

13.Set MTU output with the PFC.

14.Operation is restarted by TSTR.

SH7041A 데이터시트(PDF) 452 Page - Renesas Technology Corp

SH7041A 데이터시트(HTML) 452 Page - Renesas Technology Corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL