SH7041A datasheet(632/923 Pages) RENESAS

632 / 923 page

594

17.3.2

CMCNT Count Timing

One of four clocks (

φ/8, φ/32, φ/128, φ/512) obtained by dividing the system clock (CK) can be

selected by the CKS1, CKS0 bits of the CMCSR. Figure 17.3 shows the timing.

N – 1

N + 1

Internal clock

CMCNT input

clock

CMCNT

Figure 17.3 Count Timing

17.4

Interrupts

17.4.1

Interrupt Sources and DTC Activation

The CMT has a compare match interrupt for each channel, with independent vector addresses

allocated to each of them. The corresponding interrupt request is output when the interrupt request

flag CMF is set to 1 and the interrupt enable bit CMIE has also been set to 1.

When activating CPU interrupts by interrupt request, the priority between the channels can be

changed by using the interrupt controller settings. See section 6, Interrupt Controller (INTC), for

details.

Interrupt requests can also be used as data transfer controller (DTC) activating sources. In this

case, channel priorities are fixed. See section 8, Data Transfer Controller (DTC), for details.

17.4.2

Compare Match Flag Set Timing

The CMF bit of the CMCSR register is set to 1 by the compare match signal generated when the

CMCOR register and the CMCNT counter match. The compare match signal is generated upon

the final state of the match (timing at which the CMCNT counter matching count value is

updated). Consequently, after the CMCOR register and the CMCNT counter match, a compare

match signal will not be generated until a CMCNT counter input clock occurs. Figure 17.4 shows

the CMF bit set timing.

SH7041A 데이터시트(PDF) 632 Page - Renesas Technology Corp