SH7041A datasheet(154/923 Pages) RENESAS

154 / 923 page

116

FD E

MM E

Interrupt acceptance

IRQ

m1 m2 1 m3 1

5 + m1 + m2 + m3

Instruction (instruction

replaced by interrupt

exception processing)

Overrun fetch

Interrupt service routine

start instruction

Instruction fetch (instruction fetched from memory where program is stored).

Instruction decoding (fetched instruction is decoded).

Instruction execution (data operation and address calculation is performed

according to the results of decoding).

Memory access (data in memory is accessed).

Figure 6.5 Pipeline when an IRQ Interrupt is Accepted

6.6

Data Transfer with Interrupt Request Signals

The following data transfers can be done using interrupt request signals:

• Activate DMAC only, without generating CPU interrupt

• Activate DTC only, CPU interrupts according to DTC settings

Among interrupt sources, those designated as DMAC activating sources are masked and not input

to the INTC. The masking condition is listed below:

Mask condition = DME • (DE0 • source selection 0 + DE1

× source selection 1 + DE2 •

source selection 2 + DE3 • source selection 3)

The INTC masks CPU interrupts when the corresponding DTE bit is a 1. The DTE clear condition

and interrupt source flag clear condition are listed below.

DTE clear condition = DTC transfer end • DTECLR

Interrupt source flag clear condition = DTC transfer end •

DTECLR + DMAC transfer end

Where: DTECLR = DISEL + counter 0.

Figure 6.6 shows a control block diagram.

SH7041A 데이터시트(PDF) 154 Page - Renesas Technology Corp