SH7041A datasheet(308/923 Pages) RENESAS

308 / 923 page

270

Table 11.12 DMAC Internal Status

Item

Address Reload On

Address Reload Off

SAR

H'FFFF8408

H'FFFF840C

DAR

H'FFFFF004

DMATCR

H'0000007C

Bus rights

Released

Maintained

DMAC operation

Halted

Processing continues

Interrupts

Not issued

Transfer request source flag clear

Executed

Not executed

Notes: 1. Interrupts are executed until the DMATCR value becomes 0, and if the IE bit of the

CHCR is set to 1, are issued regardless of whether the address reload is on or off.

2. If transfer request source flag clears are executed until the DMATCR value becomes 0,

they are executed regardless of whether the address reload is on or off.

3. Designate burst mode when using the address reload function. There are cases where

abnormal operation will result if it is executed in cycle steal mode.

4. Designate a multiple of four for the TCR value when using the address reload function.

There are cases where abnormal operation will result if anything else is designated.

To execute more than four transfers with the address reload on, make the transfer request source

issue another transfer request signal.

11.4.5

Example of DMA Transfer between External Memory and SCI1 Send Side

(Indirect Address On)

In this example, DMAC channel 3 is used, an indirect address designated external memory is the

transfer source and the SCI1 sending side is the transfer destination.

Table 11.13 indicates the transfer conditions and the setting values of each of the registers.

SH7041A 데이터시트(PDF) 308 Page - Renesas Technology Corp