WM8804 datasheet(31/66 Pages) WOLFSON

31 / 66 page

Production Data

WM8804

PD Rev 4.1 September 2007

S/PDIF TRANSMITTER

The S/PDIF transmitter generates the S/PDIF frames, and outputs on the TX0 pin. The transmitted

data can be sourced from one of two places, selectable using the TXSRC register. The transmitter

can be powered down using the SPDIFTXD register bit.

ADDRESS

BIT

LABEL

DEFAULT

DESCRIPTION

TXVAL_SF0

Overwrite Mode S/PDIF Transmitter Validity Sub-

Frame 0

0 = transmit validity = 0

1 = transmit validity = 1

TXVAL_SF1

Overwrite Mode S/PDIF Transmitter Validity Sub-

Frame 1

0 = transmit validity = 0

1 = transmit validity = 1

PLL4

06H

TXVAL_

OVWR

S/PDIF Transmitter Validity Overwrite Mode Enable

0 = disabled, validity bit is 0 when the S/PDIF

transmitter sources PCM audio interface, or it matches

the S/PDIF input validity when the S/PDIF transmitter

sources the S/PDIF receiver.

1 = enabled, validity bit transmitted for subframe 0 is

defined by TXVAL_SF0, validity bit transmitted for

subframe 1 is defined by TXVAL_SF1.

TXSRC

S/PDIF Transmitter Data Source

0 = S/PDIF received data.

1 = Audio interface received data

R21

SPDTX4

15h

TXSTATSRC

S/PDIF Transmitter Channel Status Data Source

0 = Received channel status data

1 = Transmit channel status registers

Note 1: Only used if TXSRC=0

Note 2: See section User Data below

R30

PWRDN

1Eh

SPDIFTXPD

S/PDIF Transmitter Powerdown Enable

0 = S/PDIF transmitter enabled

1 = S/PDIF transmitter disabled

Table 33 S/PDIF Transmitter Control

The WM8804 also transmits the preamble and VUCP bits (Validity, User Data, Channel Status and

Parity bits).

VALIDITY BIT

By default, set to 0 (to indicate valid data) with the following exceptions:

TXSRC=0 (S/PDIF receiver), where Validity is the value recovered from the S/PDIF input

stream by the S/PDIF receiver.

TXVAL_OVWR=1, where Validity is the value set in registers TXVAL_SF0 and TXVAL_SF1.

USER DATA

Set to 0 as User Data configuration is not supported in the WM8804 – if TXSRC=0 and TXSTATSRC

=0 (S/PDIF receiver) User Data is set by the receiver.

WM8804 데이터시트(PDF) 31 Page - Wolfson Microelectronics plc

WM8804 데이터시트(HTML) 31 Page - Wolfson Microelectronics plc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66

데이터시트 다운로드

링크 URL