M58PR512LE datasheet(31/119 Pages) STMICROELECTRONICS

31 / 119 page

M58PR256LE, M58PR512LE, M58PR001LE

Command interface

31/119

4.13

Set Configuration Register command

The Set Configuration Register command writes a new value to the Configuration Register.

Two bus write cycles are required to issue the Set Configuration Register command.

●

The first cycle sets up the Set Configuration Register command and the address

corresponding to the Configuration Register content.

●

The second cycle writes the Configuration Register data and the confirm command.

The Configuration Register data must be written as an address during the bus write cycles,

such as A0 = CR0, A1 = CR1, …, A15 = CR15. Addresses A16-Amax are ignored.

Read operations output the array content after the Set Configuration Register command is

issued.

The Read Electronic Signature command is required to read the updated contents of the

Configuration Register.

4.14

Block Lock command

The Block Lock command is used to lock a block and prevent program or erase operations

from changing the data in it. All blocks are locked after power-up or reset.

Two bus write cycles are required to issue the Block Lock command.

●

The first bus cycle sets up the Block Lock command.

●

The second bus write cycle latches the block address and locks the block.

The lock status can be monitored for each block using the Read Electronic Signature

command. Table 22 shows the lock status after issuing a Block Lock command.

Once set, the block lock bits remain set even after a hardware reset or power-down/power-

up. They are cleared by a Block Unlock command.

Refer to Section 12: Block locking for a detailed explanation. See Appendix C, Figure 25:

Main array and EFA locking operations flowchart and pseudocode for a flowchart for using

the Lock command.

4.15

Block Unlock command

The Block Unlock command unlocks a block, allowing the block to be programmed or

erased.

Two bus write cycles are required to issue the Block Unlock command.

●

The first bus cycle sets up the Block Unlock command.

●

The second bus write cycle latches the block address and unlocks the block.

The lock status can be monitored for each block using the Read Electronic Signature

command. Table 22 shows the protection status after issuing a Block Unlock command.

Refer to Section 12: Block locking for a detailed explanation and Appendix C, Figure 25:

Main array and EFA locking operations flowchart and pseudocode for a flowchart for using

the Block Unlock command.

M58PR512LE 데이터시트(PDF) 31 Page - STMicroelectronics

M58PR512LE 데이터시트(HTML) 31 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL