L99PM72PXP datasheet(22/128 Pages) STMICROELECTRONICS

22 / 128 page

Detailed description

L99PM72PXP

22/128

Doc ID 023553 Rev 3

configuration, the input status is updated according to the cyclic sense timing; therefore,

reading the input status in this mode may not reflect the actual status).

2.2.9

Cyclic contact supply

In V1_standby and VBat_standby modes, any high side driver output (OUT1..4, OUTHS) can be

used to periodically supply external contacts.

The timing is selectable by SPI

Timer 1: period is X s. The on-time is 10 ms resp. 20 ms: with X

 {1, 2, 3, 4s}

Timer 2: period is X ms. The on-time is 100 µs resp. 1 ms: with X

 {10, 20, 50, 200 ms}

Timer 1 and Timer 2 are re-started with every valid write command to CR3 (CSN low to high

transition). The timers start with the off-phase.

2.2.10

Timer interrupt / wake-up of microcontroller by timer

During standby modes the cyclic wake up feature, configured via SPI, allows waking up the

µC after a programmable timeout according to timer1 or timer 2.

From V1_standby mode, the L99PM72PXP wakes up (after the selected timer has elapsed)

and sends an interrupt signal (via RxDL/NINT pin) to the µC. The device enters active mode

and the watchdog is started with a long open window. The microcontroller can send the

device back into V1_standby after finishing its tasks.

From Vbat_standby mode, the L99PM72PXP wakes up (after the selected timer has elapsed),

turns on the V1 regulator and provides an NReset signal to the µC. The device enters active

mode and the watchdog is started with a long open window. The microcontroller can send

the device back into Vbat_standby after finishing its tasks.

2.3

Functional overview (truth table)

Table 5.

Functional overview (truth table)

Function

Comments

Operating modes

Active Mode

V1_standby

static mode

(cyclic sense)

VBat_standby

static mode

(cyclic sense)

Voltage regulator, V1

VOUT=5V

On(1)

Off

Voltage regulator, V2

VOUT=5V

On/ Off(2)

On(2) / Off

Reset generator

Off

Window watchdog

V1 monitor

Off (ON: IV1 >ICMP-

threshold and

ICMP =0)

Off

Wake up

Off

Active(3)

HS-cyclic supply

Oscillator

time base

On / Off

On(2) / Off

Relay driver

Off

L99PM72PXP 데이터시트(PDF) 22 Page - STMicroelectronics

L99PM72PXP 데이터시트(HTML) 22 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL