| 전자부품 데이터시트 검색엔진 |
|
7733 데이터시트(PDF) 303 Page - Renesas Technology Corp |
|
|
|||||||||||||||||||||||||||||
7733 데이터시트(HTML) 303 Page - Renesas Technology Corp |
|
303 / 940 page ![]() WATCHDOG TIMER 7733 Group User’s Manual 10-6 10.2.2 Operation in stop mode In the stop mode, the watchdog timer stops operating. Immediately after the stop mode is terminated, the watchdog timer operates as follows. (1) When stop mode is terminated by a hardware reset Supply of internal clock φ starts immediately after the stop mode is terminated, and the microcomputer performs the “operation after reset.” (Refer to chapter “13. RESET.”) The watchdog timer frequency selection flag becomes “0,” and the watchdog timer starts counting of the main clockV1 divided by 512 from “FFF16.” Main clockV1: Refer to chapter “14. CLOCK GENERATING CIRCUIT.” (2) When stop mode is terminated by an interrupt request generated According to bit state listed in Table 10.2.2, the watchdog timer operates as “a” or “b” described below. a. Supply of internal clock φ starts immediately after the stop mode is terminated, and the routine of the interrupt which is used to terminate the stop mode is executed. From “FFF16,” the watchdog timer restarts counting of a count source which was counted just before the STP instruction is executed (Note 1). b. Immediately after the stop mode is terminated, the watchdog timer starts counting of a count source (Note 2) from “FFF16.” Supply of internal clock φ starts when the watchdog timer’s most significant bit becomes “0.” (At this time, a watchdog timer interrupt request is not generated.) When supply of internal clock φ starts, the microcomputer executes the routine of the interrupt which is used to terminate the stop mode. From “FFF16,” the watchdog timer restarts counting of a count source which was counted just before the STP instruction is executed (Note 1). Notes 1: Clock f32 or f512 is counted. 2: When the system clock selection bit = “0,” clock f32 is counted. When the system clock selection bit = “1” and the port-Xc selection bit = “0,” clock f8 is counted. 10.2 Operation description |
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |