HCS12 datasheet(335/452 Pages) FREESCALE

335 / 452 page

S12CPUV2 Reference Manual, Rev. 4.0

Freescale Semiconductor

335

8.6 Instruction Tagging

The instruction queue and cycle-by-cycle CPU activity can be reconstructed

in real time or from trace history that was captured by a logic analyzer.

However, the reconstructed queue cannot be used to stop the CPU at a

specific instruction, because execution has already begun by the time an

operation is visible outside the MCU. A separate instruction tagging

mechanism is provided for this purpose.

Executing the BDM TAGGO command configures two MCU pins for

tagging. The TAGLO signal shares a pin with the LSTRB signal, and the

TAGHI signal shares the BKGD pin. Tagging information is latched on the

falling edge of ECLK, as shown in Figure 8-5.

Figure 8-5. Tag Input Timing

Table 8-2 shows the functions of the two independent tagging pins. The

presence of logic level 0 on either pin at the fall of ECLK tags (marks) the

associated byte of program information as it is read into the instruction

queue. Tagging is allowed in all modes. Tagging is disabled when BDM

becomes active.

Table 8-2. Tag Pin Function

TAGHI

TAGLO

Tag

No tag

Low byte

High byte

Both bytes

E CLOCK

LSTRB/TAGLO

BKGD/TAGHI

TAGS ARE APPLIED TO PROGRAM INFORMATION

CAPTURED ON THIS E CLOCK TRANSITION

LSTRB VALID

TAGLO

TAGHI

VALID

HCS12 데이터시트(PDF) 335 Page - Freescale Semiconductor, Inc