68HC05CL48 datasheet(36/145 Pages) MOTOROLA

36 / 145 page

GENERAL RELEASE SPECIFICATION

June 11, 1997

MOTOROLA

INTERRUPTS

MC68HC05CL48

4-4

REV 2.0

interrupt will occur as soon as the interrupt mask bit is cleared. The latch will be

cleared by RESET or cleared automatically during fetch of the EXTERNAL

Interrupt vectors. Therefore, one (and only one) external interrupt edge could be

latched during the interrupt mask bit is set.

The service routine address is speciﬁed by the contents of $FFFA and $FFFB.

Figure 4-2 shows both a block diagram and the two methods for the interrupt line

(IRQ) to the processor. The ﬁrst method is single pulses on the interrupt line

spaced far enough apart to be serviced. The minimum time between pulses is a

function of the number of cycles required to execute the interrupt service routine

plus 21 cycles. Once a pulse occurs, the next pulse should not occur until the

MCU software has exited the routine (an RTI occurs). The second conﬁguration

shows several interrupt line “wire-ANDed” to perform the interrupts at the

processor. Thus, if after servicing one interrupt and the interrupt line remains low,

then the next interrupt is recognized.

NOTE

INTO is located at bit-1 of the Option Register at $001F, and is set

by reset. The Option Register can only be written once after reset.

68HC05CL48 데이터시트(PDF) 36 Page - Motorola, Inc