910GL datasheet(400/426 Pages) INTEL

400 / 426 page

Testability

400

Datasheet

15.2

XOR Test Mode Initialization for DDR

XOR test mode (DDR) can be entered by pulling the reserved ballout RSV (located at F15) low

through the de-assertion of external reset (RSTIN#). It was intended that no clocks should be

required to enter this test mode; however, it is recommended that customers used the following

sequence.

On power up, hold PWROK, PCIRST#, and reserved ballout RSV (located at F15) low and start

external clocks, refer to the timing diagram below. After a few clock cycles, pull PWROK high.

After ~3–4 clocks, de-assert PCIRST# (pull it high). Release reserved ballout RSV (located at

F15). No external drive. Allow the clocks to run for an additional 32 clocks. Begin testing the

XOR chains. Refer to timing diagram in below.

15.3

XOR Test Mode Initialization for DDR2

XOR test mode (DDR2) can be entered by pulling reserved ballout RSV(located at F15) and

MTYPE low through the de-assertion of external reset (RSTIN#). It was intended that no clocks

should be required to enter this test mode; however, it is recommended that customers use the

following sequence.

On power up, hold PWROK, PCIRST#, and reserved ballout RSV (located at F15) low and start

external clocks. After a few clock cycles, pull PWROK high. After ~3-4 clocks, de-assert

PCIRST# (pull it high). Release reserved ballout RSV (located at F15) and MTYPE. No external

drive. Allow the clocks to run for an additional 32 clocks. Begin testing the XOR chains. Refer to

Figure 15-1.

Figure 15-1. XOR Test Mode Initialization Cycles

PWROK

RSV_F15

MTYPE

Don’t Care

RSTIN#

1 if DDR1; 0 if DDR2

~3-4 Clocks

32 clocks

Start XOR testing

XOR_Chain_Tim

910GL 데이터시트(PDF) 400 Page - Intel Corporation