AX2000 datasheet(124/262 Pages) MICROSEMI

124 / 262 page

Detailed Specifications

2- 11 0

R ev isio n 1 8

Programming

Device programming is supported through the Silicon Sculptor II, a single-site, robust and compact

device programmer for the PC. Up to four Silicon Sculptor IIs can be daisy-chained and controlled from a

single PC host. With standalone software for the PC, Silicon Sculptor II is designed to allow concurrent

programming of multiple units from the same PC when daisy-chained.

Silicon Sculptor II programs devices independently to achieve the fastest programming times possible.

Each fuse is verified by Silicon Sculptor II to ensure correct programming. Furthermore, at the end of

programming, there are integrity tests that are run to ensure that programming was completed properly.

Not only does it test programmed and nonprogrammed fuses, Silicon Sculptor II also provides a self-test

to test its own hardware extensively.

Programming an Axcelerator device using Silicon Sculptor II is similar to programming any other antifuse

device. The procedure is as follows:

1. Load the *.AFM file.

2. Select the device to be programmed.

3. Begin programming.

When the design is ready to go to production, Microsemi offers device volume-programming services

either through distribution partners or via our In-House Programming Center.

In addition, BP Microsystems offers multi-site programmers that provide qualified support for Axcelerator

devices.

For more details on programming the Axcelerator devices, please refer to the Silicon Sculptor II User’s

Guide

AX2000 데이터시트(PDF) 124 Page - Microsemi Corporation