CS494002 datasheet(88/100 Pages) CIRRUS

88 / 100 page

12.3 Pin Definitions

FILT1 — Phase-Locked Loop Filter

Connects to an external filter for the on-chip phase-locked loop.

FILT2 — Phase Locked Loop Filter

Connects to an external filter for the on-chip phase-locked loop.

CLKIN, XTALI — External Clock Input/Crystal Oscillator Input

CS49400 clock input. This pin accepts an external clock input signal that is used to drive the

internal core logic. When in internal clock mode (CLKSEL == VSS), this input is connected to

the internal PLL from which all internal clocks are derived. When in external clock mode

(CLKSEL == VDD), this input is connected to the DSP clock. Alternatively, a 12.288 mhZ

crystal oscillator can be connected between XTALI and XTALO. INPUT

XTALO — Crystal Oscillator Output

Crystal oscillator output. OUTPUT

CLKSEL — DSP Clock Select

This pin selects the internal source clock. When CLKSEL is low, CLKIN is connected to the

internal PLL from which all internal clocks are derived. When CLKSEL is high, the PLL is

bypassed and the external clock directly drives all input logic. INPUT

FDAT7 — DSPAB Bidirectional Data Bus

FDAT6

FDAT5

FDAT4

FDAT3

FDAT2

FDAT1

FDAT0

In parallel host mode, these pins provide a bidirectional data bus to DSPAB. These pins have

an internal pull-up.

BIDIRECTIONAL - Default: INPUT

FA0, FSCCLK — Host Parallel Address Bit Zero or Serial Control Port Clock

In parallel host mode, this pin serves as one of two address input pins used to select one of

four parallel registers. In serial host mode, this pin serves as the serial control clock signal,

specifically as the SPI clock input. INPUT

CS494002 데이터시트(PDF) 88 Page - Cirrus Logic