 |
전자부품 데이터시트 검색엔진 |
|
|
전자부품 데이터시트 검색엔진 |
|
C161PI 데이터시트(PDF) 42 Page - Infineon Technologies AG |
|
|
|||||||||||||||||||||||||||||
C161PI 데이터시트(HTML) 42 Page - Infineon Technologies AG |
|
|
42 / 82 page  &3, Data Sheet 40 1999-07 Power-down mode supply current (5V) with RTC running , PDR5 8) –200 + 25* I OSC µA 9 DD = 9DDmax I OSC in [MHz] 9) Power-down mode supply current (5V) with RTC disabled , PDO5 –50 µA 9 DD = 9DDmax 9) 1) This specification is not valid for outputs which are switched to open drain mode. In this case the respective output will float and the voltage results from the external circuitry. 2) These parameters describe the RSTIN pullup, which equals a resistance of ca. 50 to 250 K Ω. 3) The maximum current may be drawn while the respective signal line remains inactive. 4) The minimum current must be drawn in order to drive the respective signal line active. 5) This specification is only valid during Reset, or during Hold- or Adapt-mode. During Hold mode Port 6 pins are only affected, if they are used (configured) for CS output and the open drain function is not enabled. 6) Not 100% tested, guaranteed by design characterization. 7) The supply current is a function of the operating frequency. This dependency is illustrated in the figure below. These parameters are tested at 9 DDmax and maximum CPU clock with all outputs disconnected and all inputs at 9 IL or 9IH. The oscillator also contributes to the total supply current. The given values refer to the worst case, ie. I PDRmax. For lower oscillator frequencies the respective supply current can be reduced accordingly. 8) This parameter is determined mainly by the current consumed by the oscillator. This current, however, is influenced by the external oscillator circuitry (crystal, capacitors). The values given refer to a typical circuitry and may change in case of a not optimized external oscillator circuitry. 9) This parameter is tested including leakage currents. All inputs (including pins configured as inputs) at 0 V to 0.1 V or at 9 DD – 0.1 V to 9DD, 9REF = 0 V, all outputs (including pins configured as outputs) disconnected. DC Characteristics (Standard Supply Voltage Range) (continued) (Operating Conditions apply) Parameter Symbol Limit Values Unit Test Condition min. max. |
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |
Korean ▼
English
Chinese
German
Japanese
Russian
Korean
Spanish
French
Italian
Portuguese
Polish
Vietnamese
Indian
Mexican
British
New Zealand
