| 전자부품 데이터시트 검색엔진 |
|
PI7C8150BMA-33 데이터시트(PDF) 41 Page - Pericom Semiconductor Corporation |
|
|
|||||||||||||||||||||||||||||
PI7C8150BMA-33 데이터시트(HTML) 41 Page - Pericom Semiconductor Corporation |
|
41 / 107 page ![]() PI7C8150B ASYNCHRONOUS 2-PORT PCI-TO-PCI BRIDGE Page 41 of 107 April 2015 – Revision 2.1 4 ADDRESS DECODING PI7C8150B uses three address ranges that control I/O and memory transaction forwarding. These address ranges are defined by base and limit address registers in the configuration space. This chapter describes these address ranges, as well as ISA-mode and VGA- addressing support. 4.1 ADDRESS RANGES PI7C8150B uses the following address ranges that determine which I/O and memory transactions are forwarded from the primary PCI bus to the secondary PCI bus, and from the secondary bus to the primary bus: Two 32-bit I/O address ranges Two 32-bit memory-mapped I/O (non-prefetchable memory) ranges Two 32-bit prefetchable memory address ranges Transactions falling within these ranges are forwarded downstream from the primary PCI bus to the secondary PCI bus. Transactions falling outside these ranges are forwarded upstream from the secondary PCI bus to the primary PCI bus. No address translation is required in PI7C8150B. The addresses that are not marked for downstream are always forwarded upstream. 4.2 I/O ADDRESS DECODING PI7C8150B uses the following mechanisms that are defined in the configuration space to specify the I/O address space for downstream and upstream forwarding: I/O base and limit address registers The ISA enable bit The VGA mode bit The VGA snoop bit This section provides information on the I/O address registers and ISA mode. Section 4.4 provides information on the VGA modes. To enable downstream forwarding of I/O transactions, the I/O enable bit must be set in the command register in configuration space. All I/O transactions initiated on the primary bus will be ignored if the I/O enable bit is not set. To enable upstream forwarding of I/O transactions, the master enable bit must be set in the command register. If the master- enable bit is not set, PI7C8150B ignores all I/O and memory transactions initiated on the secondary bus. The master-enable bit also allows upstream forwarding of memory transactions if it is set. 15-0048 |
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |