STM8S datasheet(257/467 Pages) STMICROELECTRONICS

257 / 467 page

DocID14587 Rev 14

257/467

RM0016

8-bit basic timer (TIM4, TIM6)

261

Bit 7 MSM: Master/slave mode

0: No action

1: The effect of an event on the trigger input (TRGI) is delayed to allow a perfect synchronization

between timers (through TRGO).

Bits 6:4 TS[2:0]: Trigger selection

This bit field selects the trigger input to be used to synchronize the counter.

000: Reserved

001: Internal trigger ITR1 connected to TIM1 TRGO (*)

010: Reserved

011: Internal trigger ITR3 connected to TIM5 TRGO (*)

100: Reserved

101: Reserved

110: Reserved

111: Reserved

(*) 8K low-density devices unless otherwise specified.

Note: These bits must only be changed when they are not used (e.g. when SMS = 000) to avoid

wrong edge detections at the transition.

Bit 3 Reserved.

Bits 2:0 SMS[2:0]:Clock/trigger/slave mode selection

When external signals are selected, the active edge of the trigger signal (TRGI) is linked to the

polarity selected on the external input (see Input control register and control register description).

000: Clock/trigger controller disabled - If CEN = 1, the prescaler is clocked directly by the internal

clock.

001: Reserved

010: Reserved

011: Reserved

100: Trigger reset mode - The rising edge of the selected trigger signal (TRGI) reinitializes the

counter and generates an update of the registers.

101: Gated mode - The counter clock is enabled when the trigger signal (TRGI) is high. The counter

stops (but is not reset) as soon as the trigger becomes low. Both start and stop of the counter are

controlled.

110: Trigger mode - The counter starts at a rising edge of the trigger TRGI (but it is not reset). Only

the start of the counter is controlled.

111: External clock mode 1 - Rising edges of the selected trigger (TRGI) clock the counter.

STM8S 데이터시트(PDF) 257 Page - STMicroelectronics