| 전자부품 데이터시트 검색엔진 |
|
UPD17P136ACT 데이터시트(PDF) 138 Page - NEC |
|
|
|||||||||||||||||||||||||||||
UPD17P136ACT 데이터시트(HTML) 138 Page - NEC |
|
138 / 292 page ![]() CHAPTER 13 PERIPHERAL HARDWARE 119 13.1.7 Error of Interval Time The interval time may include an error of up to –1.5 count, especially if the value set value of the modulo register is low. (1) Error when count register is cleared to 0 during counting (maximum error: –1 count) The count register of the 8-bit timer/counter is cleared to 0 when the TMnRES flag is set to 1. However, the divider circuit that generates a count pulse from the system clock is not reset. Therefore, an error of 1 cycle of the count pulse may be generated at the first count if the TMnRES flag is set to 1 and the count value is cleared to 0 during counting. An example of counting where 2 is set to the modulo register is shown below. Figure 13-6. Error When Count Register Is Cleared to 0 During Counting In this example, the coincidence signal must be output each time the count value has reached 3. However, the coincidence signal is output when the count value reaches 2 for the first time after the count has been cleared. The above error also occurs when TMnRES ← 1 at the same time as TMnEN = 1 ← 0. 12 0 1 2 Count register Count pulse Output of coincidence signal Count cleared (TMnRES ← 0) 2 to 3 counts |
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |