VSC8221 datasheet(91/138 Pages) MICROSEMI

91 / 138 page

VSC8221

Data Sheet

VMDS-10106 Revision 4.1

December 2006

91 of 106

106

26.15 – interrupt Status

When bit 26.15 is set to “1”, an unacknowledged interrupt is pending. The cause of the interrupt can be determined by reading

the interrupt status bits in this register. This bit is automatically cleared when read.

26.14 – Reserved

26.13 – Link State-Change interrupt Status

When the link status of the PHY changes, bit 26.13 is set to “1” if bit 25.13 is also set to “1”. This bit is automatically cleared

when read.

26.12 – Reserved

26.11 – Auto-Negotiation Error interrupt Status

When an error is detected by the Auto-Negotiation state machine, bit 26.11 is set to “1” if bit 25.11 is also set to “1”. This bit is

automatically cleared when read.

26.10 – Auto-Negotiation-Done / interlock Done interrupt Status

When the auto-negotiation state machine finishes a negotiation process, bit 26.10 is set to “1” if bit 25.10 is also set to “1”. This

bit is automatically cleared when read.

26.9 – inline Powered Device Detected interrupt Status

When a device requiring inline power over CAT-5 is detected, bit 26.9 is set to “1” if bit 25.9 is also set to “1”. This bit is

automatically cleared when read.

26.8 – Symbol Error interrupt Status

When a symbol error is detected by the descrambler, bit 26.8 is set to “1” if bit 25.8 is also set to “1”. This bit is automatically

cleared when read.

26.7 – Descrambler Lock-Lost interrupt Status

When the descrambler loses lock, bit 26.7 is set to “1” if bit 25.7 is also set to “1”. This bit is automatically cleared when read.

26.6 – TX FiFO interrupt Status

When the TX FiFO enters an underflow or overflow condition, bit 26.6 is set to “1” if bit 25.6 is also set to “1”. This bit is

automatically cleared when read.

26.5 – RX FiFO interrupt Status

When the RX FiFO enters an underflow or overflow condition, bit 26.5 is set to “1” if bit 25.5 is also set to “1”. This bit is

automatically cleared when read.

26.4 – Reserved

26.3 – False Carrier interrupt Status

When the PHY has detected a false carrier, bit 26.3 is set to “1” if bit 25.3 is also set to “1”. This bit is automatically cleared when

read,

26.2 – Cable impairment Detect interrupt Status

When the PHY has detected an impairment on the CAT-5 media, bit 26.3 is set to “1” if bit 25.3 is also set to “1”. This bit is

automatically cleared when read.

VSC8221 데이터시트(PDF) 91 Page - Microsemi Corporation