SH7041A datasheet(580/923 Pages) RENESAS

580 / 923 page

542

• Bit 7—A/D End Flag (ADF): This status flag indicates that A/D conversion has ended.

Bit 7: ADF

Description

Clear conditions (initial value)

• With ADF = 1, by reading the ADF flag then writing 0 in ADF

• When the DTC or DMAC are activated by an ADI interrupt

Set conditions

• Single mode: When A/D conversion ends after conversion for all

designated channels (during buffer operation, this is not set until

operation of the specified buffer has ended)

• Scan mode: After one round of A/D conversion for all specified

channels

• Bit 6—A/D Interrupt Enable (ADIE): Enables or disables interrupt requests (ADI) after A/D

conversion ends. Set the ADIE bit while conversion is suspended.

Bit 6: ADIE

Description

Disables interrupt requests (ADI) after A/D conversion ends (initial

value)

Enables interrupt requests (ADI) after A/D conversion ends

• Bit 5—A/D Start (ADST): Selects start or stop for A/D conversion. A 1 is maintained during

A/D conversions.

The ADST bit can be set to 1 by software, timer conversion start triggers, or an A/D external

trigger input pin (

ADTRG).

Bit 5: ADST

Description

A/D conversion halted (initial value)

Single mode: Start A/D conversion. Automatically cleared to 0 after

conversion for the designated channel ends.

Scan mode: Start A/D conversion. Continuous conversion until 0

cleared by software.

SH7041A 데이터시트(PDF) 580 Page - Renesas Technology Corp