HC08KL8GRSSLASHD datasheet(83/256 Pages) NXP

83 / 256 page

System Integration Module (SIM)

Reset and System Initialization

MC68HC08KL8 — Rev. 2.0

General Release Specification

System Integration Module (SIM)

All of these resets produce the vector $FFFE–FFFF ($FEFE–FEFF in

monitor mode) and assert the internal reset signal (IRST). IRST causes

all registers to be returned to their default values and all modules to be

returned to their reset states.

An internal reset clears the SIM counter (see 8.5 SIM Counter), but an

external reset does not. Each of the resets sets a corresponding bit in

the reset status register (RSR). (See 8.8 SIM Registers.)

8.4.1 External Pin Reset

The RST pin circuits include an internal pullup device. Pulling the

asynchronous RST pin low halts all processing. The PIN bit of the reset

status register (RSR) is set as long as RST is held low for a minimum of

67 CGMXCLK cycles, assuming that the POR was not the source of the

reset. See Table 8-2 for details. Figure 8-4 shows the relative timing.

Figure 8-4. External Reset Timing

Table 8-2. PIN Bit Set Timing

Reset Type

Number of Cycles Required to Set PIN

POR

4163 (4096 + 64 + 3)

All Others

67 (64 + 3)

RST

IAB

VECT H

VECT L

CGMOUT

Freescale Semiconductor, Inc.

For More Information On This Product,

Go to: www.freescale.com

HC08KL8GRS/D 데이터시트(PDF) 83 Page - NXP Semiconductors