H838532H datasheet(121/508 Pages) RENESAS

121 / 508 page

Section 5 Power-Down Modes

Rev. 1.00 May 30, 2008 Page 101 of 484

REJ09B0436-0100

Bits 6 to 4: Standby timer select 2 to 0 (STS2 to STS0)

These bits designate the time the CPU and peripheral modules wait for stable clock operation after

exiting from standby mode or watch mode to active mode due to an interrupt. The designation

should be made according to the operating frequency so that the waiting time is at least equal to

the oscillation settling time.

Bit 6

STS2

Bit 5

STS1

Bit 4

STS0

Description

Wait time = 8,192 states

(initial value)

Wait time = 16,384 states

Wait time = 32,768 states

Wait time = 65,536 states

Wait time = 131,072 states

Wait time = 2 states

(External clock mode)

Wait time = 8 states

Wait time = 16 states

Note:

In the case that external clock is input, set up the “Standby timer select” selection to

External clock mode before Mode Transition. Also, do not set up to external clock mode, in

the case that it does not use external clock.

Bit 3: Low speed on flag (LSON)

This bit chooses the system clock (

φ) or subclock (φ

SUB) as the CPU operating clock when watch

mode is cleared. The resulting operation mode depends on the combination of other control bits

and interrupt input.

Bit 3

LSON

Description

The CPU operates on the system clock (

φ)

(initial value)

The CPU operates on the subclock (

SUB)

Bit 2: Reserved bit

Bit 2 is reserved: it is always read as 1 and cannot be modified.

H838532H 데이터시트(PDF) 121 Page - Renesas Technology Corp

H838532H 데이터시트(HTML) 121 Page - Renesas Technology Corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL