H838532H datasheet(133/508 Pages) RENESAS

133 / 508 page

Section 5 Power-Down Modes

Rev. 1.00 May 30, 2008 Page 113 of 484

REJ09B0436-0100

5.7

Active (Medium-Speed) Mode

5.7.1

Transition to Active (Medium-Speed) Mode

If the

RES pin is driven low, active (medium-speed) mode is entered. If the LSON bit in SYSCR2

is set to 1 while the LSON bit in SYSCR1 is cleared to 0, a transition to active (medium-speed)

mode results from IRQ

0, IRQ1, or WKP7 to WKP0 interrupts in standby mode, timer A, timer F,

timer G, IRQ

0, or WKP7 to WKP0 interrupts in watch mode, or any interrupt in sleep mode.

transition to active (medium-speed) mode does not take place if the I bit of CCR is set to 1 or the

particular interrupt is disabled in the interrupt enable register.

Furthermore, it sometimes acts with half state early timing at the time of transition to active

(medium-speed) mode.

5.7.2

Clearing Active (Medium-Speed) Mode

Active (medium-speed) mode is cleared by a SLEEP instruction.

• Clearing by SLEEP instruction

A transition to standby mode takes place if the SLEEP instruction is executed while the SSBY

bit in SYSCR1 is set to 1, the LSON bit in SYSCR1 is cleared to 0, and the TMA3 bit in TMA

is cleared to 0. The system goes to watch mode if the SSBY bit in SYSCR1 is set to 1 and bit

TMA3 in TMA is set to 1 when a SLEEP instruction is executed.

When both SSBY and LSON are cleared to 0 in SYSCR1 and a SLEEP instruction is executed,

sleep mode is entered. Direct transfer to active (high-speed) mode or to subactive mode is also

possible. See section 5.8, Direct Transfer, below for details.

• Clearing by RES pin

When the

RES pin is driven low, a transition is made to the reset state and active (medium-

speed) mode is cleared.

5.7.3

Operating Frequency in Active (Medium-Speed) Mode

Operation in active (medium-speed) mode is clocked at the frequency designated by the MA1 and

MA0 bits in SYSCR1.

H838532H 데이터시트(PDF) 133 Page - Renesas Technology Corp