AT90SCR100 datasheet(138/433 Pages) ATMEL

138 / 433 page

138

TPR0327AY–SMS–30Jan09

AT90SCR100

The setup of the OC2x should be performed before setting the Data Direction Register for the

port pin to output. The easiest way of setting the OC2x value is to use the Force Output Com-

pare (FOC2x) strobe bit in Normal mode. The OC2x Register keeps its value even when

changing between Waveform Generation modes.

Changing the COM2x1:0 bits will take effect immediately.

13.3.5

Compare Match Output Unit

The Compare Output mode (COM2x1:0) bits have two functions. The Waveform Generator uses

the COM2x1:0 bits for defining the Output Compare (OC2x) state at the next compare match.

Also, the COM2x1:0 bits control the OC2x pin output source. Figure 13-28 shows a simplified

schematic of the logic affected by the COM2x1:0 bit setting. The I/O Registers, I/O bits, and I/O

pins in the figure are shown in bold. Only the parts of the general I/O Port Control Registers

(DDR and PORT) that are affected by the COM2x1:0 bits are shown. When referring to the

OC2x state, the reference is for the internal OC2x Register, not the OC2x pin.

Figure 13-28.

Compare Match Output Unit, Schematic

The general I/O port function is overridden by the Output Compare (OC2x) from the Waveform

Generator if either of the COM2x1:0 bits are set. However, the OC2x pin direction (input or out-

put) is still controlled by the Data Direction Register (DDR) for the port pin. The Data Direction

The port override function is independent of the Waveform Generation mode.

The design of the Output Compare pin logic allows initialization of the OC2x state before the out-

put is enabled. Note that some COM2x1:0 bit settings are reserved for certain modes of

operation. See “8-bit Timer/Counter Register Description” on page 145.

13.3.5.1

Compare Output Mode and Waveform Generation

The Waveform Generator uses the COM2x1:0 bits differently in normal, CTC, and PWM modes.

For all modes, setting the COM2x1:0 = 0 tells the Waveform Generator that no action on the

PORT

DDR

OC2x

Waveform

Generator

COM2x1

COM2x0

FOC2x

clk

I/O

AT90SCR100 데이터시트(PDF) 138 Page - ATMEL Corporation