ATtiny43U datasheet(31/182 Pages) ATMEL

31 / 182 page

8048B–AVR–03/09

Power Management and Sleep Modes

Sleep modes enable the application to shut down unused modules in the MCU, thereby saving

power. The AVR provides various sleep modes allowing the user to tailor the power consump-

tion to the application’s requirements.

When enabled, the Brown-out Detector (BOD) actively monitors the power supply voltage during

the sleep periods. To further save power, it is possible to disable the BOD in some sleep modes.

See “Software BOD Disable” on page 32 for more details.

7.1

Sleep Modes

Figure 6-1 on page 23 presents the different clock systems in ATtiny43U, and their distribution.

The figure is helpful in selecting an appropriate sleep mode. Table 7-1 below shows the different

sleep modes and their wake-up sources.

Note:

1. For INT0, only level interrupt.

To enter any of the sleep modes, the SE bit in MCUCR must be written to logic one and a

SLEEP instruction must be executed. The SM1:0 bits in the MCUCR Register select which sleep

mode (Idle, ADC Noise Reduction or Power-down) will be activated by the SLEEP instruction.

See Table 7-2 on page 34 for a summary.

If an enabled interrupt occurs while the MCU is in a sleep mode, the MCU wakes up. The MCU

is then halted for four cycles in addition to the start-up time, executes the interrupt routine, and

resumes execution from the instruction following SLEEP. The contents of the Register File and

SRAM are unaltered when the device wakes up from sleep. If a reset occurs during sleep mode,

the MCU wakes up and executes from the Reset Vector.

Note that if a level triggered interrupt is used for wake-up the changed level must be held for

some time to wake up the MCU (and for the MCU to enter the interrupt service routine). See

“External Interrupts” on page 58 for details.

7.1.1

Idle Mode

When the SM1:0 bits are written to 00, the SLEEP instruction makes the MCU enter Idle mode,

stopping the CPU but allowing Analog Comparator, ADC, Timer/Counter, Watchdog, and the

interrupt system to continue operating. This sleep mode basically halts clk

CPU and clkFLASH, while

allowing the other clocks to run.

Table 7-1.

Active Clock Domains and Wake-up Sources in the Different Sleep Modes

Active Clock Domains

Oscillators

Wake-up Sources

Sleep Mode

Idle

ADC Noise Reduction

X(1)

Power-down

X(1)

ATtiny43U 데이터시트(PDF) 31 Page - ATMEL Corporation

ATtiny43U 데이터시트(HTML) 31 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL