TLK6002 datasheet(36/96 Pages) TI

36 / 96 page

TLK6002

SLLSE34 – MAY 2010

www.ti.com

If supplying reference clock through an external clock jitter cleaning device, the VCXO used with the

external cleaning device should be chosen such that REFCLK maintains ±100 ppm accuracy during ARS

rate determination, since CLK_OUT behavior will not be deterministic during changes between settings.

Per the above table, note that CLK_OUT is always a fixed frequency and attempts to remain synchronous

(0 ppm) to the incoming serial data rate.

If reference clock of 153.6 MHz is selected, and an external clock jitter cleaning device is used, the clock

cleaning device will need to be configured to multiply the output clock by 1x, since CLK_OUT_P/N is

153.6MHz.

If reference clock of 122.88 MHz is selected, and an external clock jitter cleaning device is used, the clock

cleaning device will need to be configured to multiply the output clock by 2x, since CLK_OUT_P/N is

61.44MHz.

If reference clock of 307.2 MHz is selected, and an external clock jitter cleaning device is used, the clock

cleaning device will need to be configured to multiply the output clock by 2x, since CLK_OUT_P/N is

153.6MHz.

Figure 2-13 shows the flow of the ARS state machine:

Description

Submit Documentation Feedback

Product Folder Link(s): TLK6002

TLK6002 데이터시트(PDF) 36 Page - Texas Instruments