IMX53IEC datasheet(86/173 Pages) FREESCALE

86 / 173 page

i.MX53 Applications Processors for Industrial Products, Rev. 6

Freescale Semiconductor

Electrical Characteristics

NOTE

Table 59 provides information for both the Disp0 and Disp1 ports. However,

Disp1 port has reduced pinout depending on IOMUXC configuration and

therefore may not support all the above configurations. See the IOMUXC

table for details.

4.7.8.5

IPU Display Interface Timing

The IPU Display Interface supports two kinds of display accesses: synchronous and asynchronous. There

are two groups of external interface pins to provide synchronous and asynchronous controls accordantly.

4.7.8.5.1

Synchronous Controls

The synchronous control changes its value as a function of a system or of an external clock. This control

has a permanent period and a permanent wave form.

There are special physical outputs to provide synchronous controls:

•

The ipp_disp_clk is a dedicated base synchronous signal that is used to generate a base display

(component, pixel) clock for a display.

•

The ipp_pin_1– ipp_pin_7 are general purpose synchronous pins, that can be used to provide

HSYNC, VSYNC, DRDY or any else independent signal to a display.

The IPU has a system of internal binding counters for internal events (such as HSYNC/VSYCN and so on)

calculation. The internal event (local start point) is synchronized with internal DI_CLK. A suitable control

starts from the local start point with predefined UP and DOWN values to calculate control’s changing

points with half DI_CLK resolution. A full description of the counters system can be found in the IPU

chapter of the i.MX53 Reference Manual.

4.7.8.5.2

Asynchronous Controls

The asynchronous control is a data-oriented signal that changes its value with an output data according to

additional internal flags coming with the data.

There are special physical outputs to provide asynchronous controls, as follows:

•

The ipp_d0_cs and ipp_d1_cs pins are dedicated to provide chip select signals to two displays.

•

The ipp_pin_11– ipp_pin_17 are general purpose asynchronous pins, that can be used to provide

WR. RD, RS or any other data oriented signal to display.

NOTE

The IPU has independent signal generators for asynchronous signals

toggling. When a DI decides to put a new asynchronous data in the bus, a

new internal start (local start point) is generated. The signals generators

calculate predefined UP and DOWN values to change pins states with half

DI_CLK resolution.

IMX53IEC 데이터시트(PDF) 86 Page - Freescale Semiconductor, Inc

IMX53IEC 데이터시트(HTML) 86 Page - Freescale Semiconductor, Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL