AD9523-1SLASHPCBZ datasheet(56/60 Pages) AD

56 / 60 page

AD9523-1

Rev. B | Page 56 of 60

Table 56. Power-Down Control

Address

Bits

Bit Name

Description

[7:3]

Reserved

Reserved.

1: power-down (default).

PLL1 power-down

0: normal operation.

1: power-down (default).

PLL2 power-down

0: normal operation.

Powers down the distribution.

1: power-down (default).

0x233

Distribution

power-down

0: normal operation.

Table 57. Update All Registers

Address

Bits

Bit Name

Description

[7:1]

Reserved

Reserved.

This bit must be set to 1 to transfer the contents of the buffer registers into the active registers,

which happens on the next SCLK rising edge. This bit is self-clearing; that is, it does not have to

be set back to 0.

0x234

IO_Update

1 (self-clearing): update all active registers to the contents of the buffer registers.

EEPROM Buffer (Address 0xA00 to Address 0xA16)

Table 58. EEPROM Buffer Segment

Address

Bits

Bit Name

Description

0xA00

0xA16

[7:0]

EEPROM Buffer

Segment Register 1

to EEPROM Buffer

Segment Register 23

The EEPROM buffer segment section stores the starting address and number of bytes that are to

be stored and read back to and from the EEPROM. Because the register space is noncontiguous,

the EEPROM controller needs to know the starting address and number of bytes in the register

space to store and retrieve from the EEPROM. In addition, there are special instructions for the

EEPROM controller: operational codes (that is, IO_Update and end-of-data) that are also stored in

the EEPROM buffer segment. The on-chip default setting of the EEPROM buffer segment registers

is designed such that all registers are transferred to/from the EEPROM, and an IO_Update is issued

after the transfer (see the Programming the EEPROM Buffer Segment section).

EEPROM Control (Address 0xB00 to Address 0xB03)

Table 59. Status_EEPROM

Address

Bits

Bit Name

Description

[7:1]

Reserved

Reserved.

This read-only bit indicates the status of the data transferred between the EEPROM and the buffer

STATUS0 pin when Register 0x232, Bit 4, is set.

0: data transfer is complete.

0xB00

Status_EEPROM

(read only)

1: data transfer is not complete.

Table 60. EEPROM Error Checking Readback

Address

Bits

Bit Name

Description

[7:1]

Reserved

Reserved.

This read-only bit indicates an error during the data transfer between the EEPROM and the buffer.

0: no error; data is correct.

0xB01

EEPROM data error

(read only)

1: incorrect data detected.

AD9523-1/PCBZ 데이터시트(PDF) 56 Page - Analog Devices

AD9523-1/PCBZ 데이터시트(HTML) 56 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60

데이터시트 다운로드

링크 URL