| 전자부품 데이터시트 검색엔진 |
|
GXM 데이터시트(PDF) 201 Page - National Semiconductor (TI) |
|
|
|
|||||||||||||||||||||||||||||
GXM 데이터시트(HTML) 201 Page - National Semiconductor (TI) |
|
201 / 244 page ![]() Revision 3.1 201 www.national.com 9.0 Instruction Set This section summarizes the Geode GXm processor instruction set and provides detailed information on the instruction encodings. The instruction set is broken into four categories: • Processor Core Instruction Set - listed in Table 9-27 on page 213 • FPU Instruction Set - listed in Table 9-29 on page 225 • MMX Instruction Set - listed in Table 9-31 on page 230 • National Semiconductor Extended MMX Instruction Set - listed in Table 9-33 on page 235 These tables provide information on the instruction encod- ing, and the instruction clock counts for each instruction. The clock count values for these tables are based on the following assumptions 1. All clock counts refer to the microprocessor core internal clock frequency. For example, clock doubled GXm processor cores will reference a clock frequency that is twice the bus frequency. 2. The instruction has been prefetched, decoded and is ready for execution. 3. Bus cycles do not require wait states. 4. There are no local bus HOLD requests delaying processor access to the bus. 5. No exceptions are detected during instruction execu- tion. 6. If an effective address is calculated, it does not use two general register components. One register, scaling and displacement can be used within the clock count shown. However, if the effective address calculation uses two general register components, add one clock to the clock count shown. 7. All clock counts assume aligned 32-bit memory/ IO operands. 8. If instructions access a 32-bit operand on odd addresses, add one clock for read or write and add two clocks for read and write. 9. For non-cached memory accesses, add two clocks (clock doubled GXm processor cores) or four clocks (clock tripled GXm processor cores), assuming zero wait state memory accesses. 10. Locked cycles are not cacheable. Therefore, using the LOCK prefix with an instruction adds additional clocks as specified in item 9 above. |
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |