ST72325AR7-Auto datasheet(70/243 Pages) STMICROELECTRONICS

70 / 243 page

Obsolete

Product(s)

- Obsolete

Product(s)

Power saving modes

ST72325xxx-Auto

70/243

Doc ID 13770 Rev 3

Figure 28.

Active Halt mode flowchart

Peripheral clocked with an external clock source can still be active.

Before servicing an interrupt, the CC register is pushed on the stack. The I[1:0] bits of the CC register are

set to the current software priority level of the interrupt routine and restored when the CC register is

popped.

8.4.2

Halt mode

The Halt mode is the lowest power consumption mode of the MCU. It is entered by

executing the ‘HALT’ instruction when the OIE bit of the Main Clock Controller Status

beeper (MCC/RTC)for more details on the MCCSR register).

The MCU can exit Halt mode on reception of either a specific interrupt (see Table 21:

Interrupt mapping) or a RESET. When exiting Halt mode by means of a RESET or an

interrupt, the oscillator is immediately turned on and the 256 or 4096 CPU cycle delay is

used to stabilize the oscillator. After the start up delay, the CPU resumes operation by

servicing the interrupt or by fetching the reset vector which woke it up (see Figure 30).

When entering Halt mode, the I[1:0] bits in the CC register are forced to ‘10b’ to enable

interrupts. Therefore, if an interrupt is pending, the MCU wakes up immediately.

In Halt mode, the main oscillator is turned off causing all internal processing to be stopped,

including the operation of the on-chip peripherals. All peripherals are not clocked except the

HALT INSTRUCTION

RESET

CPU

OSCILLATOR

PERIPHERALS(1)

I[1:0] BITS

OFF

FETCH RESET VECTOR

OR SERVICE INTERRUPT

CPU

OSCILLATOR

PERIPHERALS

I[1:0] BITS

OFF

XX(2)

CPU

OSCILLATOR

PERIPHERALS

I[1:0] BITS

XX(2)

256 OR 4096 CPU CLOCK

CYCLE DELAY

(MCCSR.OIE = 1)

INTERRUPT

ST72325AR7-Auto 데이터시트(PDF) 70 Page - STMicroelectronics

ST72325AR7-Auto 데이터시트(HTML) 70 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL