HCS08 datasheet(95/316 Pages) NXP

95 / 316 page

Chapter 7 Central Processor Unit (S08CPUV2)

MC9S08SG8 MCU Series Data Sheet, Rev. 8

Freescale Semiconductor

of an operand for a test and then use relative addressing mode to specify the branch destination address

when the tested condition is true. For BRCLR, BRSET, CBEQ, and DBNZ, the addressing mode listed in

the instruction set tables is the addressing mode needed to access the operand to be tested, and relative

addressing mode is implied for the branch destination.

7.3.1

Inherent Addressing Mode (INH)

In this addressing mode, operands needed to complete the instruction (if any) are located within CPU

registers so the CPU does not need to access memory to get any operands.

7.3.2

Relative Addressing Mode (REL)

Relative addressing mode is used to specify the destination location for branch instructions. A signed 8-bit

offset value is located in the memory location immediately following the opcode. During execution, if the

branch condition is true, the signed offset is sign-extended to a 16-bit value and is added to the current

contents of the program counter, which causes program execution to continue at the branch destination

address.

7.3.3

Immediate Addressing Mode (IMM)

In immediate addressing mode, the operand needed to complete the instruction is included in the object

code immediately following the instruction opcode in memory. In the case of a 16-bit immediate operand,

the high-order byte is located in the next memory location after the opcode, and the low-order byte is

located in the next memory location after that.

7.3.4

Direct Addressing Mode (DIR)

In direct addressing mode, the instruction includes the low-order eight bits of an address in the direct page

(0x0000–0x00FF). During execution a 16-bit address is formed by concatenating an implied 0x00 for the

high-order half of the address and the direct address from the instruction to get the 16-bit address where

the desired operand is located. This is faster and more memory efficient than specifying a complete 16-bit

address for the operand.

7.3.5

Extended Addressing Mode (EXT)

In extended addressing mode, the full 16-bit address of the operand is located in the next two bytes of

program memory after the opcode (high byte first).

7.3.6

Indexed Addressing Mode

Indexed addressing mode has seven variations including five that use the 16-bit H:X index register pair

and two that use the stack pointer as the base reference.

HCS08 데이터시트(PDF) 95 Page - NXP Semiconductors