SH7041A datasheet(513/923 Pages) RENESAS

513 / 923 page

475

• Bit 3—Stop Bit Length (STOP): Selects one or two bits as the stop bit length in the

asynchronous mode. This setting is used only in the asynchronous mode. It is ignored in the

clock synchronous mode because no stop bits are added.

In receiving, only the first stop bit is checked, regardless of the STOP bit setting. If the second

stop bit is 1, it is treated as a stop bit, but if the second stop bit is 0, it is treated as the start bit

of the next incoming character.

Bit 3: STOP

Description

One stop bit (initial value). In transmitting, a single bit of 1 is added at

the end of each transmitted character.

Two stop bits. In transmitting, two bits of 1 are added at the end of each

transmitted character.

• Bit 2—Multiprocessor Mode (MP): Selects multiprocessor format. When multiprocessor

format is selected, settings of the parity enable (PE) and parity mode (O/

E) bits are ignored.

The MP bit setting is used only in the asynchronous mode; it is ignored in the clock

synchronous mode. For the multiprocessor communication function, see section 14.3.3,

Multiprocessor Communication.

Bit 2: MP

Description

Multiprocessor function disabled (initial value)

Multiprocessor format selected

• Bits 1 and 0—Clock Select 1 and 0 (CKS1 and CKS0): These bits select the internal clock

source of the on-chip baud rate generator. Four clock sources are available;

φ, φ/4, φ/16, or

φ/64. For further information on the clock source, bit rate register settings, and baud rate, see

section 14.2.8, Bit Rate Register (BRR).

Bit 1: CKS1

Bit 0: CKS0

Description

φ (initial value)

φ/4

φ/16

φ/64

SH7041A 데이터시트(PDF) 513 Page - Renesas Technology Corp