ST20-GP1 datasheet(88/116 Pages) STMICROELECTRONICS

88 / 116 page

ST20-GP1

88/116

15 Byte-wide parallel port

The byte-wide parallel port is provided to drive an external device using 8-bit half-duplex streamed

I/O and two control wires.

The byte-wide parallel port has 2 modes of operation, as follows:

•

it can operate as an ASIC interface. In this mode the external data transfer is controlled by

the EMI strobes and addresses.

•

it can operate as a byte-wide parallel link (PLink) using an external asynchronous transfer

mechanism to control transfers.

The mode of operation is determined by the setting of the conﬁguration registers, see Section 15.3.

15.1 EMI mode operation

In this mode the EMI is in total control of the PlinkData0-7 pins. The PlinknotAck output is forced

to its ‘inactive’ state during this mode.

The interface to the external device is controlled by the EMI. The bottom 8 bits of the EMI data bus

(MemData0-7) are redirected (copied) to the PlinkData0-7 pins. The direction of these pads is

controlled by the EMI. The external timing and data transfer of this activity is controlled by the

programmed conﬁguration of the EMI bank 2 (see Section 9.5 on page 58).

15.2 Parallel link (DMA) mode operation

In this mode the byte-wide parallel port is a DMA (direct memory access) engine which performs

memory transfers to and from the external links on behalf of a controller (the CPU). The parallel link

is unidirectional and only transfers data in one direction across the memory bus at any given time.

The byte-wide parallel port defaults to input (to the ST20-GP1) when the ST20-GP1 is reset (with

the notRST pin) to prevent contention, and can be used for DMA functions without interfering with

memory bank 2. However to access external registers via the PlinkData0-7 pins, the bit in the

PlinkEmi register (see Table 15.1) must be set by software. This results in all accesses to external

memory bank 2 being diverted via the port rather than MemData0-7, allowing both register and

DMA access to the external peripheral. External memory bank 2 must be dedicated solely for this

use while the register access of this external peripheral is enabled.

Being half-duplex, the direction of the link when in DMA mode must be selected in software by

setting the bit in the PlinkIO register (see Table 15.2 below). Data transfer for the parallel port (for

DMA transfers) occur by the use of a channel. When the EMI is using these pads the directionality

is controlled by the EMI and not the DMA control register.

15.3 Conﬁguration registers

There are three control registers for the parallel port which are programmed by use of

devsw

(device store) and

devlw (device load) instructions. The base address for the parallel port

conﬁguration registers is given in the Memory Map chapter.

ST20-GP1 데이터시트(PDF) 88 Page - STMicroelectronics