H838532H datasheet(358/508 Pages) RENESAS

358 / 508 page

Section 10 Serial Communication Interface

Rev. 1.00 May 30, 2008 Page 338 of 484

REJ09B0436-0100

(7) Relation between RDR Reads and Bit RDRF

In a receive operation, SCI3 continually checks the RDRF flag. If bit RDRF is cleared to 0 when

reception of one frame ends, normal data reception is completed. If bit RDRF is set to 1, this

indicates that an overrun error has occurred.

When the contents of RDR are read, bit RDRF is cleared to 0 automatically. Therefore, if bit RDR

is read more than once, the second and subsequent read operations will be performed while bit

RDRF is cleared to 0. Note that, when an RDR read is performed while bit RDRF is cleared to 0,

if the read operation coincides with completion of reception of a frame, the next frame of data may

be read. This is illustrated in figure 10.17.

Communication

line

RDRF

RDR

Frame 1

Frame 2

Frame 3

Data 1

RDR read

Data 1 is read at point

(A)

Data 2

Data 3

Data 2

(A)

Data 2 is read at point

(B)

Figure 10.17 Relation between RDR Read Timing and Data

In this case, only a single RDR read operation (not two or more) should be performed after first

checking that bit RDRF is set to 1. If two or more reads are performed, the data read the first time

should be transferred to RAM, etc., and the RAM contents used. Also, ensure that there is

sufficient margin in an RDR read operation before reception of the next frame is completed. To be

precise in terms of timing, the RDR read should be completed before bit 7 is transferred in

synchronous mode, or before the STOP bit is transferred in asynchronous mode.

H838532H 데이터시트(PDF) 358 Page - Renesas Technology Corp